• ENE-EPS-3
  • 電力供應系統
  • 避免設備過載運轉
  • Many electrical devices have inductive loads, such as:
    ●AC single-phase and 3-phase motors (see Section 3.6)
    ●variable speed drives (see Section 3.6.3)
    ●transformers (see Section 3.5.4)
    ●high intensity discharge lighting (see Section 3.10)
    These all require both active electrical power and reactive electrical power. The active electrical power is converted into useful mechanical power, while the reactive electrical power is used to maintain the device’s magnetic fields. This reactive electrical power is transferred periodically in both directions between the generator and the load (at the same frequency as the supply). Capacitor banks and buried cables also take reactive energy.
    Vector addition of the real (active) electrical power and the reactive electrical power gives the apparent power. Power generation utilities and network operators must make this apparent power available and transmit it. This means that generators, transformers, power lines, switchgear, etc. must be sized for greater power ratings than if the load only drew active electrical power.
    Power supply utilities (both on-site and off-site) are faced with extra expenditure for equipment and additional power losses. External suppliers, therefore, make additional charges for reactive power if this exceeds a certain threshold. Usually, a certain target power factor of cos ϕ of between 1.0 and 0.9 ( lagging) is specified, at which point the reactive energy requirement is significantly reduced. A simple explanation is given in Annex 7.17.

    If the power factor is corrected, for example by installing a capacitor at the load, this totally or partially eliminates the reactive power draw at the power supply company. Power factor correction is at its most effective when it is physically near to the load and uses state-of-the-art technology.
    The power factor can change over time so needs to be checked periodically (depending on site and usage, and these checks can be anything from 3 to 10 years apart), as the type of equipment and the supplies listed (above) change over time. Also, as capacitors used to correct the power factor deteriorate with time, these also require periodic testing (most easily carried out by checking if the capacitors are getting warm in operation).
    Other measures to take are:
    ●to minimise operation of idling or lightly loaded motors (see Section 3.6)
    ●to avoid operation of equipment above its rated voltage
    ●to replace standard motors as they burn out with energy efficient motors (see Section 3.6)
    ●even with energy efficient motors, however, the power factor is significantly affected by variations in load. A motor must be operated near its rated capacity to realise the benefits of a high power factor design (see Section 3.6).

    電力供應系統設施,不論是現場或不在現場都面臨額外的開銷及電力損失。所以外部電力供應者會就超過某一門檻的虛功率收取額外費用。通常功率因素(cos ϕ)的值約訂在1.0到0.9(落後)之間,以抑低虛功需求量。

    電功率因素(cos ϕ) =實電力/視在(表觀)電力


  • None reported.

  • All sites.


  • External suppliers may make additional charges for excessive reactive electrical power if the correction factor in the installation is less than 0.95 (see Annex 7.11).
    The cost of power correction is low. Some new equipment ( e.g. high efficiency motors) addresses power correction.


  • Energy Efficiency (2009) 3.5.1